Field Calibration Kit (1507)

With a 1507 Calibration Kit, the accuracy of your TORQO® can be verified or a complete on-site calibration can be performed by the user.

Contained in this kit is a precision Calibration Disk (C-19935), a ball bearing load support assembly (D-19777) and the necessary hardware to use this kit.

The Calibration Disk is manufactured to a tolerance that will insure an accuracy of +/- .02%. In addition, a certificate insuring the traceability of these dimensions to NIST is supplied.

Calibration Weights (19777)

The weights required for performing a calibration are not included in the calibration kit. They are sold as a separate item because they will vary with the torque capacity of the TORQO and in some cases the user may already have suitable weights. Our weights are always supplied with traceable certification.

 

---

Torqo Gold Bottle (1612)
Torqo Gold Bottle, Small 1to 6 in-lb (1612SM
Torqo Gold Bottle, Standard 7 to 17 in-lb (1612SD)
Torqo Gold Bottle, Large 18 to 35 in-lb (1612LG)

The Model 1612 Gold Bottle is used to verify the operational repeatability of torque testing instruments. This bottle is constructed with high energy permanent magnets and is pre-set at the factory to a customer specified torque value of between 1 to 35 inch pounds. Each Gold Bottle is labeled with its exact torque rating and repeats to an accuracy of +/- 0.2 inch pounds.

Since the cap torque of this bottle is the torque produced by the permanent magnets, the value will always be the same. Therefore, when tested on the Torque Tester, the measured value will always be the same unless something has changed within the Torque Testing Instrument itself. The user is thus able to quickly check the Torque Tester without having to go through the calibration procedure.

The Gold Bottle is provided with a 28mm to 43mm cap to match the customer's chuck. Vibrac Europe can also provide the bottle with any customer supplied cap at no additional cost.